LIS302DL DATASHEET PDF

STMicroelectronics LISDL: available from 8 distributors. Explore Sensors on Octopart: the fastest source for datasheets, pricing, specs and availability. LISDL from STMICROELECTRONICS >> Specification: MEMS Accelerometer , 3-Axis, Digital, X, Y, Z, ± 2g, Technical Datasheet: LISDL Datasheet. LISDL datasheet, LISDL circuit, LISDL data sheet: STMICROELECTRONICS – MEMS motion sensor 3-axis – ±2g/±8g smart digital output piccolo.

Author: Zulkirg Moogut
Country: Dominica
Language: English (Spanish)
Genre: Life
Published (Last): 2 June 2015
Pages: 417
PDF File Size: 3.62 Mb
ePub File Size: 11.87 Mb
ISBN: 360-4-69666-413-1
Downloads: 79930
Price: Free* [*Free Regsitration Required]
Uploader: Vobei

Set your preferences in register 0x20 and 0x21 See page in the datasheet. The other device I only had to write to and never read.

That’s SPI mode 3. All I am getting on the LCD is and it does not change. Please do not post bug Reports on this forum. It shows that the clock SPC idles at a high level and does a positive transition in the middle of each data cell.

  DT266 CLAMP METER MANUAL PDF

Then post a compilable test program that demonstrates the failure. Wed May 12, 2: Some of the posts helped.

MEMS Motion Sensor 3-axis – ± 2g/± 8g Smart Digital Output piccolo Accelerometer

Sun Feb 08, 2: Thank you both for replying. There are a few things: You must initialize the chip, its default turned off.

The chip is powered-down by default. Below is the code I have been trying. Dead line in 3 days and I am yet to write into a register, wuph I think I am going to order another one and give it another try.

I will post back if I am still facing the issue. I have been looking at the data sheet. Wed Feb 04, 1: Send them to support ccsinfo. It shows that for a read operation the first bit out the MSB is supposed to be a ‘1’ bit.

LISDL Datasheet

I have tried a few different settings for the 0x20 and 0x21 register. I have been trying all the things I can think of but am unable to get them to talk to each other. Here’s what datashfet manual says: I have searched the forum the best I can and have borrowed code from some lis302dll.

  DANIEL GOLEMAN EL LIDER RESONANTE CREA MAS PDF

Even with the registers the way they where before shouldnt I be getting something other than all the time?

LISDL 데이터시트(PDF) – STMicroelectronics

CCS does not monitor this forum on a regular basis. Display posts from previous: Sat Feb 07, 1: Due to an errata in 18f, I need a NOP between the spi statements otherwise the chip will hang.

I have the following: Hi, I have it up and running on a 18f Fri Feb 06, 2: Next task is to interface the LCD to the micro